|
Design
All hardware and labeling recessed for their physical protection in
structural wells. Wells give added stacking and distortion resistance,
also flex under drop loads to reduce shock imputa decided advantage
over stiff containers.
Double wall construction at parting line gives maximum strength for
mounting hardware and captivates cushioning system.
Container is either free-breathing per ATA Spec 300, Category 1, with
open end gasket or airtight with closed-end gasket.
Meets Mil Standard 810E.
Molded-in male and female positive lock stacking ribs.
Closure is with "over center" spring loaded catch with provision
for security wire.
Strappingg indents molded-in for 1/2" wide steel or plastic extra
closure.
Handling-full hand grip, spring loading handle.
Hardware attached with stainless steel rivets to unique "molded-in"
steel insert.
Lid retainer is galvanized steel aircraft cable.
Performance
Dent Resistance: Resilient Polethylene
defies permanent dents, even under severe accidental impacts.
Fungus Resistance: There are no
nutrient materials in the container construction to support fungus life.
Water Resistance: (Rainfall) Comples
with the water resistance spray method ASTM D951 allowing no water penetration
at any altitude.
Temperature Resistance: Container
material suitable for withstanding exposure to the elements and storage
in a range of -40 degrees F to +140 degrees F.
Impact and Vibration Resistance:
Container fully loaded can withstand 160 free fall impacts minimum per
ASTM D775 (corners, edges and flat faces) and 2 hours of vibration per
ASTM D999 procedure B, without evidence of detioration from cracking or
denting and will maintain waterproof, air-tight seal.
Low Maintenance
Solvent Resistance: Unaffected
by common industrial solvents, skydrol, jet fuels, etc.
Abrasion Resistance: Scratches
and scrapes go almost unnoticed with coloring solid throughout wall thickness.
Cleanability: Easy to clean with
solvents or mild detergent solution for a like-new look, even after many
trips.
Corrosion Resistance: All-plastic
construction means no rust or paint to blister or peel. Hardware is cadmium
plated for maximum weather-ability.
Note: Recessing of hardware in wells minimizes danger of abrasion.
State-of-the-Art
Drop Testing
Shock level testing at our lab from 12 to 120 Gs per Mil Spec.
|
